1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
|
From: Lukas Wunner <lukas@wunner.de>
Date: Sat, 27 Oct 2018 10:15:33 +0200
Subject: [PATCH] pinctrl: bcm2835: Use raw spinlock for RT compatibility
Origin: https://www.kernel.org/pub/linux/kernel/projects/rt/4.19/older/patches-4.19.13-rt10.tar.xz
[Upstream commit 71dfaa749f2f7c1722ebf6716d3f797a04528cba]
The BCM2835 pinctrl driver acquires a spinlock in its ->irq_enable,
->irq_disable and ->irq_set_type callbacks. Spinlocks become sleeping
locks with CONFIG_PREEMPT_RT_FULL=y, therefore invocation of one of the
callbacks in atomic context may cause a hard lockup if at least two GPIO
pins in the same bank are used as interrupts. The issue doesn't occur
with just a single interrupt pin per bank because the lock is never
contended. I'm experiencing such lockups with GPIO 8 and 28 used as
level-triggered interrupts, i.e. with ->irq_disable being invoked on
reception of every IRQ.
The critical section protected by the spinlock is very small (one bitop
and one RMW of an MMIO register), hence converting to a raw spinlock
seems a better trade-off than converting the driver to threaded IRQ
handling (which would increase latency to handle an interrupt).
Cc: Mathias Duckeck <m.duckeck@kunbus.de>
Signed-off-by: Lukas Wunner <lukas@wunner.de>
Acked-by: Julia Cartwright <julia@ni.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
---
drivers/pinctrl/bcm/pinctrl-bcm2835.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
--- a/drivers/pinctrl/bcm/pinctrl-bcm2835.c
+++ b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
@@ -90,7 +90,7 @@ struct bcm2835_pinctrl {
struct gpio_chip gpio_chip;
struct pinctrl_gpio_range gpio_range;
- spinlock_t irq_lock[BCM2835_NUM_BANKS];
+ raw_spinlock_t irq_lock[BCM2835_NUM_BANKS];
};
/* pins are just named GPIO0..GPIO53 */
@@ -461,10 +461,10 @@ static void bcm2835_gpio_irq_enable(stru
unsigned bank = GPIO_REG_OFFSET(gpio);
unsigned long flags;
- spin_lock_irqsave(&pc->irq_lock[bank], flags);
+ raw_spin_lock_irqsave(&pc->irq_lock[bank], flags);
set_bit(offset, &pc->enabled_irq_map[bank]);
bcm2835_gpio_irq_config(pc, gpio, true);
- spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
+ raw_spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
}
static void bcm2835_gpio_irq_disable(struct irq_data *data)
@@ -476,12 +476,12 @@ static void bcm2835_gpio_irq_disable(str
unsigned bank = GPIO_REG_OFFSET(gpio);
unsigned long flags;
- spin_lock_irqsave(&pc->irq_lock[bank], flags);
+ raw_spin_lock_irqsave(&pc->irq_lock[bank], flags);
bcm2835_gpio_irq_config(pc, gpio, false);
/* Clear events that were latched prior to clearing event sources */
bcm2835_gpio_set_bit(pc, GPEDS0, gpio);
clear_bit(offset, &pc->enabled_irq_map[bank]);
- spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
+ raw_spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
}
static int __bcm2835_gpio_irq_set_type_disabled(struct bcm2835_pinctrl *pc,
@@ -584,7 +584,7 @@ static int bcm2835_gpio_irq_set_type(str
unsigned long flags;
int ret;
- spin_lock_irqsave(&pc->irq_lock[bank], flags);
+ raw_spin_lock_irqsave(&pc->irq_lock[bank], flags);
if (test_bit(offset, &pc->enabled_irq_map[bank]))
ret = __bcm2835_gpio_irq_set_type_enabled(pc, gpio, type);
@@ -596,7 +596,7 @@ static int bcm2835_gpio_irq_set_type(str
else
irq_set_handler_locked(data, handle_level_irq);
- spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
+ raw_spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
return ret;
}
@@ -1047,7 +1047,7 @@ static int bcm2835_pinctrl_probe(struct
for_each_set_bit(offset, &events, 32)
bcm2835_gpio_wr(pc, GPEDS0 + i * 4, BIT(offset));
- spin_lock_init(&pc->irq_lock[i]);
+ raw_spin_lock_init(&pc->irq_lock[i]);
}
err = gpiochip_add_data(&pc->gpio_chip, pc);
|
